I need to find a screwdriver that fits this, and if anyone out there in Internet-land knows what kind of screw this is it would be very helpful.
The screw in question (or screws, since there’s four of them) is located on an IBM drive-tray for my servers. I would very much like being able to replace the drives myself, and thus need to know what kind of screw it is. I’m leaning towards this being some weird IBM proprietary screw, but I also feel it should be pretty easy to locate a driver for it.
Basically it looks a lot like some torx-variant, but it has a pin in the middle. I hope you can make it out from my crappy macro-photography.
I’m not sure what the exact standard or specification is named but I think I have seen tools at my work that would get the job done.
It seems like some kind of security torx.
I found this one. I think it will work perfectly and it’s not that expensive
Best regards from Germany
Det där är väl en sån där “tamperproof” torx, dvs en vanlig torx med en pinne i mitten.
Du kan i regel använda vanliga ihåliga torx av rätt storlek för jobbet.
http://www.sizes.com/tools/screw_drive.htm
Det ska finnas på CO men kan vara bökigt o hitta, då hela poängen är väl att dessa skruvar inte ska tas lös
Farsan hade då dessa ihåliga torxar vill jag minnas men det hjälper väl inte. Dock finns dom!
http://www.justfuckinggoogleit.com
Kallar torx med stift eller tamper proof torx… Finns att köpa hylsor på biltema, classe, jula mfl.
99 spänn på Jula
http://www.jula.se/bitssats-100-delar-124789
No Problemos! I have several of these bits in my toolbox. Just ask if you wanna borrow… Or, check-out Clas Ohlson